Middle Third Fender Section

The Middle Third is the splash-stopper that sits over the tire crown on OneWheel Pint, PintX, and PintS. Our 3-piece design lets you pair it with the front/rear pieces for full-coverage control. Each part is 3D-printed in impact-resistant plastic with a snug, tire-hugging profile that won’t flex into the wheel, even on hard carves. Install is simple: align with the factory holes, snug the screws, and ride—no permanent mods. By blocking the vertical “rooster” that normally kicks straight up, the Middle Third keeps grit off your legs, deck, and footpads while preserving a clean, low-profile look. The action-camera (GoPro-style) mount on both edges (right for regular, left for goofy) of the board for a clean, cinematic angle of your ride and quick clip changes. Mix and match colors to build your own style, then swap sections anytime—you’re never locked into one setup.

Features:

• Fits Pint®, PintX®, & PintS®
• 3D Printed 3-Part Fender
• Mix and Match Colors
• GoPro® Style Universal Mount (Accessories coming soon!)
• Includes Longer Bolts & Hex Key
• "Fender Delete" (aka stock bezel) Required for Install
• Made to Order
• Want a custom color? Send us an email!

Care: Rinse with water and mild soap after muddy sessions. Never use harsh solvents.

Get it from OneWheel®:

Fender Delete - Pint & PintX

OneWheel - Pint

OneWheel - PintX

OneWheel - PintS

OneWheel, Pint, Pint X, PintS, Fender Delete amoung other names and terms are trademarks of Future Motion Inc and not owned by Lils Fenders.